B30 Emergency Ballast

B50 Cold-Pak

Features Free Shipping for this item • Full light output with one 32 W T8; One- or two-lamp illumination from 48 VDC power supply • Initial Light Output 1100 - 3100 Lumens •AC Sensing Voltage 120/277 VAC, 60 Hz • AC Input Current 90 mA • Illumination Time 90 Minutes • Dimensions 9.4” x 2.4” x 1.5” (238 mm x 60 mm x 38 mm) Mounting Center 8.9” (226 mm) • Full Warranty 1 Year (NOT pro-rata) • Factory Warranty - Yes • Authorized Distributor - Yes
B50 Cold-Pak
Application The CB90-48 central battery ballast provides backup lighting to existing fluorescent fixtures in buildings such as telephone exchanges or other facilities that have dedicated systems and a 48 VDC central battery supply. The central battery ballast consists of a solid-state inverter, EMI filter, AC voltage-sensing circuitry and switching circuitry in one compact case. The CB90-48 can be used with most 13 - 215 W (2’ - 8’) T8, T9, T10, or T12 fluorescent lamps without integral starters, including U-shaped, HO, VHO, circline and energy-saving (see Table 1). It is also compatible with most one-, two-, three- and four-lamp electronic, standard, energy-saving and dimming AC ballasts. If used in a fixture intended for DC operation only, no AC ballast is necessary. The CB90-48 is suitable for indoor locations. It is not suitable for air handling heated air outlets or wet, damp or hazardous locations. For information about specific lamp and ballast compatibility, please call the factory. Recommended applications include: telephone central offices and other facilities equipped with a 48 VDC power supply. OPERATION When AC power fails, the CB90-48 senses the loss of AC power and automatically switches to DC power, operating either one or two lamps. Duration of illumination is determined by the capacity of the central battery supply. When AC power is restored, the CB90-48 returns to the standby mode, allowing the AC ballast to operate the lamps. INSTALLATION The CB90-48 requires a 48 VDC power source and an unswitched source of AC power (120 or 277 VAC). It does not affect normal fixture operation and may be used with either a switched or unswitched fixture. The central battery ballast must be fed from the same AC branch circuit as the AC ballast. The CB90-48 may be installed inside, on top of or remote from the fixture. The central battery ballast may be remotely installed up to half the distance the AC ballast manufacturer recommends remoting the AC ballast from the lamp or up to 50 feet,whichever is less. Installation is not recommended with fixtures where the ambient temperature may fall below 0°C. UL and CODE COMPLIANCE The CB90-48 has been tested by Underwriters Laboratories in accordance with standards set forth in UL 924, “Emergency Lighting and Power Equipment,” and is UL Listed for factory or field installation.
More Information

B50 Cold-PakSpec Sheet

Wattage 14
Case Quantity 1
Warranty 5 Year
Input Voltage 120/277
Order Code B50 Cold-Pak
UPC 663015105261
Wattage 14 Watts
Manufacturer Philips Bodine
Write Your Own Review
You're reviewing:B50 Cold-Pak
Your Rating